Labels:text | diagram | skeleton OCR: BLADE REPLACEMENT 1. Cycle arm and blade assembly to a position on the windshield where removal of blade assembly canbe performed without difficulty. Tum ignition key off at desired position. 2. To remove blade assembly from wiper arm, pull up on spring lock and pull blade assembly from pin (View AJ. Be sure spring lock is not pulled excessively or it will become distorted. 3. To install, push the blade assembly onto the pin so that the spring lock engages the pin (View A). Be sure the blade assembly is securely attached 10 pin ELEMENT REPLACEMENT 1. In the plastic backing strip which is part of the rubber blade assembly, there is an 11, 11mm (7/16 inch) long notch located approximately one inch from either end. Locate either notch. 2. Place the frame of the wiper blade assembly on a firm surface with either notched end of the backing strip visible. 3. Grasp the frame portion of the wiper blade assembly and push down until the blade assembly is tightly 4. With the blade assembly in the bowed position, grasp the tip of the backing strip firmly, pulling up and bowed. twisting C.C.W. at the same time. The backing strip will then snap out of the retaining tab on the end of the frame. 5. Lift the wiper blade assembly from the surface and slide the backing strip down the frame until the notch lines up with the next retaining tab, twist slightly, and the backing strip will snap out. Continue this operation with the remaining tabs until the blade element is completely detached from the frame. 6 To install blade element. reverse the above procedure, making sure all six (6) tabs are locked to the backing Strip before installing blade to wiper arm. GUIDE NOTCH FIND NOTCH ON ONE SIDE 4) TWIST & PULL-UP BOW THE FRAME FORCE DOWN DISENGAGE THE OTHER GUIDES BLADE REPLACEMENT LIFT THE SPRING LOCK TO REMOVE THE BLADE NON SLIP FROM THE WIPER ARM SURFACE VIEW A
(.png)
